Installing the dram simm, Figure b‐3 – Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 User Manual
Page 58
Memory Locations and Replacement Procedures
B-4 Mode Switch Bank Settings and Optional Installations
3.
Pull the DRAM SIMM straight up and remove it from the connector fingers.
Installing the DRAM SIMM
To install a DRAM SIMM, refer to
and proceed as follows:
1.
Push the connector arms away from the DRAM SIMM enough to insert the DRAM SIMM into
the connector fingers.
2.
Insert the DRAM SIMM straight down between the connector fingers enough for the tabs on
the connector arms to align with the two DRAM SIMM alignment notches.
3.
Push the DRAM SIMM down into the connector fingers. Then rotate the two connector arms
toward the DRAM SIMM to lock it into place.
Figure B-3 Removing the Existing DRAM SIMM
1 Connector arms
2 DRAM SIMM
3 Connector fingers
Б
В
А
А
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.