Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 - Manual (Page 56)

Memory Locations and Replacement Procedures
B-2 Mode Switch Bank Settings and Optional Installations
• Switch 7 – Clear Persistent Data. Changing the position of this switch clears Persistent Data on
the next power‐up of the module. All user‐entered parameters, such as the IP address, module
names, etc., are reset to the factory default settings. Once the module resets, you can either use
the factory default settings or reenter your own parameters.
• Switch 8 – Clear Admin Password. Changing the position of this switch clears the admin
password, and restores the factory default password on the next power‐up of the module.
Once the module resets, you can either use the factory default settings or reenter your own
password.
Memory Locations and Replacement Procedures
In the event that the DIMM (Dual In‐line Memory Module) or DRAM SIMM (DRAM Single In‐
line Memory Module) (FLASH memory) needs to be replaced, the following sections describe
how to access, locate and replace these memory modules. If you have questions concerning the
replacement of either memory module, refer to “
Getting Help ” on page xiv for details on how to
contact Enterasys Networks.
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin password to
its factory default setting.
Figure B-1 Mode Switch Location
1 Mode switch bank