Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 - Manual (Page 23)

Matrix DFE-Platinum Series Module Installation Guide 3-1
3
Installation
This chapter provides the instructions to install the DFE‐Diamond module and optional XFP
interface modules.
A Phillips screwdriver is required to install an optional interface module into the DFE‐Diamond
module. Follow the order of the sections listed below to correctly install the DFE‐Diamond
module.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Important Notice
Read the Release Notes associated with the DFE-Diamond module to check for any exceptions to the
supported features and operation documented in this guide.
Note: Unless otherwise noted, the installation instructions for the DFE-Diamond modules apply to
both the 7KR4297-02 and 7KR4297-04 DFE-Diamond modules.
For information about... Refer to page...
Unpacking the DFE-Diamond Module 3-2
Installing an Optional XFP Module 3-2
Backplane Connections and Installation Rules 3-3
Installing Module into Matrix E7 or Matrix N7 Chassis 3-6
Installing Module into Matrix N3 Chassis 3-9
Connecting to the Network 3-10
Connecting to COM Port for Local Management 3-11
Completing the Installation 3-16