Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 - Manual (Page 59)

Memory Locations and Replacement Procedures
Matrix DFE-Platinum Series Module Installation Guide B-5
DIMM Replacement Procedure
In the event that the DIMM needs to be replaced, the following sections explain how to remove
and install the DIMM. If you have questions concerning the replacement of the DIMM, refer to
“
Getting Help ” on page xiv for details on how to contact Enterasys Networks.
Removing the DIMM
To remove the existing DIMM, refer to Figure B‐5 and proceed as follows:
1. Locate the DIMM connector on the main PC board. (Refer back to Figure B‐2 for the DIMM
location on the 7KR4297‐02.)
2. Push the connector arms away from the DIMM, as shown in Figure B‐5 , and simultaneously
lift the DIMM enough to release it from the connector fingers.
Figure B-4 Installing the DRAM SIMM
1 DRAM SIMM Connector arms 3 Connector fingers
2 DRAM SIMM 4 DRAM SIMM alignment notches (2)
Б
В
Г
Г
А
А
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.