Enterasys Networks Enterasys Diamond Distributed Forwarding Engine 7KR4297-04 - Manual (Page 60)

Memory Locations and Replacement Procedures
B-6 Mode Switch Bank Settings and Optional Installations
3. Rotate the DIMM upwards, then remove it from the connector fingers.
Installing the DIMM
To install a DIMM, refer to Figure B‐6 and proceed as follows:
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two DIMM
alignment notches. With the two connector arms spread outward, push the DIMM down
between the connector arms. Then release the two connector arms to lock the DIMM into
place.
Figure B-5 Removing the Existing DIMM
1 Connector arms 2 DIMM 3 Connector fingers
Б
В
А
А
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.