Step four: parts return – HP LaserJet Enterprise M806x+ Black and White Laser Printer User Manual
Page 70
3.
Use the adjustment wheels on the accessory to align the accessory with the edge of the product.
NOTE:
If the accessory is not correctly aligned with the product, excessive paper jams may occur.
4.
Connect the finishing accessory interface cable.
5.
Connect the product power cord, and then turn on the product.
Step four: Parts return
The following URL provides information on how to return parts to HP for reuse and recycling:
NOTE:
HP recommends responsible disposal of the defective stapler/stacker.
Step five: Configure the default hole punch location
1.
From the Home screen on the product control panel, scroll to and touch the
Administration
button.
2.
Open the following menus:
●
Stapler/Stacker Settings
●
Hole Punching
3.
Select a hole punch location from the list of options, and then touch the
Save
button. The following hole
punch options are available for either a 2/3 Hole Puncher or 2/4 Hole Puncher:
Hole punch location
2/3 Hole Puncher
2/4 Hole Puncher
None
Two left or top
62
Chapter 2 Install and configure the finishing accessories
ENWW