Christie M Series WU14K-M WUXGA 3DLP Projector (No Lens) - Manual (Page 60)

Projector status LEDs
Identify the input LED state colors and meaning.
Looking from the back of the projector, the LEDs represent, from left to right; Lamp 1, Lamp 2, Power,
and Status. The LEDs display the colors as shown below.
Projector state LEDs LED state
Hard boot All All LEDs amber—Please wait
Standby mode Lamps 1 and 2 Off—Lamps are off
Power Amber—AC is present but projector is off or standby
Shutter Green—Shutter is open
Amber—Shutter is closed
Warm-up (Powering on
from standby) All LEDs cycle green from left to right
Normal operation Lamps 1 and 2 Amber—Lamp time has expired and lamp should be replace
Power Green—Projector is powered up and operating normally
Shutter Green—Shutter is open
Amber—Shutter is closed
Cool-down All LEDs cycle from left to right
Error Lamp 1 and 2 Amber—Lamp time has expired and lamp should be replace
Flashing red—Lamp time has expired and lamp should be replace
Power Flashing red—Error has occurred. Details are displayed on the
status display.
Software upgrade in
progress All The pattern will alternate between Amber and Off
Lamp Regeneration in
progress Lamp 1 and 2 Flashing Green—The lamp is being switched off for its
regeneration period to extend lamp life (typically 15 minutes every
24 hours)
Power Green—On
Amber—Standby
Shutter Green—Shutter is open
A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
• The Status LEDS are cycling green
• The LCD displays the warning Image Processor Upgrading
• The LED on the image processor card flashes green
• The web page shows a warning that the image processor card is upgrading
• When this occurs, the projector should not be AC power cycled and the image processor card
should not be removed
Monitoring and maintaining the projector
M Series User Guide 60
020-101948-02 Rev. 1 (08-2018)
Copyright © 2018 Christie Digital Systems USA, Inc. All rights reserved.