Creating a channel – Christie M Series WU14K-M WUXGA 3DLP Projector (No Lens) User Manual

Page 24

The first five items in this table are analog RGB with various sync combinations indicating Sync Source
when editing the channel:

Abbreviation

Signal types

—

No Sync

4WH

Composite (four wire) on HC input

4WV

Composite (four wire) on V input

Sync-on-green (four wire)

Separate H,V (five-wire)

5WR

Separate H,V swapped (five-wire)

SVid

S-Video

CVid

Composite Video

Dig

Digital

DSDI

Digital Dual Link HD-SDI

DVI

Digital DVI

HDMI

Digital HDMI

HSDI

Digital HD-SDI

SDI

Digital SDI

3GA

Digital 3G-SDI (Level A)

3GB

Digital 3G-SDI (Level B)

DisplayPort

1. To display the Main menu, press Menu from the presentation level.
2. To display the Channel Setup menu, press 3 or move the highlight to the Channel Setup option

and press Enter.

3. To see the remaining channels not visible in the initial display of channels, press the Up and

Down keys.

Creating a channel

To use a new source with the projector, a new channel must be created so that the projector responds

to an input signal from that source.
A new channel can be created automatically, or it can be copied from an existing channel and then
edited as necessary.
When you select a direct input (Slot 1, Slot 2, Slot 3, or Slot 4), any existing channels in the projector
are searched for matching input and signal parameters–this only occurs if Auto Source is enabled on
these channels. If no match to the incoming input signal is found in currently defined channels, a new
channel is temporarily created based on factory-defined defaults for this type of signal. The channel
number assigned is the lowest available number from 01-99.
Note the following:

Managing channels

M Series User Guide

020-101948-02 Rev. 1 (08-2018)