Unboxing, 1 unboxing the up300, Nboxing – Afinia H+1 3D Printer User Manual

Page 8

3. Unboxing

3.1 Unboxing the

H+1

Cut open the tape on the top of the cardboard box, and open the box from the top.

Take out the two boards on the top foam, and remove the top foam.

Remove the plastic cover and the square shaped foam wrapping around the

machine.

4. With two people, l

ift the printer out of the cardboard box using two handles on both

sides of the

printer, and place it on a flat surface.

Open the Top Lid and remove all the

tie-downs from the gantry

and foams inside

the printer. There are

six

tie-downs

in the machine.

Open the Front Door, and take out the two foams and two extruders beneath the

build platform

, as shown in the

figures below:

Take out the roll of filament, the accessory box and the power cord

located

at the

bottom

of the cardboard box.

Put all the foams back to the box, and keep the box for the future use.

Contact

Afinia 3D

Figure 1.3

Turn the foam 90 degrees and then

take it out of the machine.

Figure 1.2

Take out the extruder.