Afinia H+1 3D Printer - Manual (Page 26)

5.7 Config
Config section contains five parameters, and the Network Settings .
Name : it’s the printer’s name, you can change it on the
Afinia
Studio software.
The default name is the printer’s S.N number.
Sound : Toggle the click sound while using touchscreen.
Preheat : Toggle the build plate preheating option. If it is
on, the machine will start pre-heating 15 minutes ahead
of the start of the print job.
You can read the introduction of Preheating in
Maintenance -> Preheat in the Software User Manual.
Private : Toggle the printer to set a password for private
use. Once this option is on, you can set a password for
your printer and your printer will not be accessible by
other users on the same network without obtaining the
password.
Password : The password for the printer to protect your
printer from other people’s access. Click the text field to
enter your password.
Contact
Afinia 3D
: support@
afinia.com
25
34°C | 37°C 500
252212
Preheat
Sound
Name
Private
Password 123456
Figure 5.8 Config