2 remove the printed model, Emove, Rinted – Afinia H+1 3D Printer User Manual
Page 51: Model
7.2 Remove the Printed model
To remove the printed model from the print board of the
H+1
, it is recommended to
wear gloves for protection, Take out the print board with its front handle, place the
print board on a flat surface perpendicularly, and start scarping the model off the
print board from one corner of the model using the scraper that comes with the
machine.
Once getting the model off the print board, use the scraper to remove any plastic
remains on the print board until there is nothing left on the surface. Place the print
board back into the build chamber, and be ready for the next print.
If you begin seeing issues with rafts not adhering well to the print surface, try wiping
down the surface with isopropyl alcohol and allowing it to dry. This will remove any
oils or debris that may have been transferred to the surface over time.
Contact
Afinia 3D
50