Afinia H+1 3D Printer - Manual (Page 13)

4.3 Load Filament
The
H+1
comes with no filament installed. You have to manually install the filament
before printing anything. In order to get a good quality print, we recommend use
Afinia's
filaments.
You will find a reel of 500g ABS filament that comes
inside
the
H+1
cardboard box.
To install the filament, please following the instruction below:
1.
Find the filament reel that comes with the machine.
2.
Remove the vacuum bag.
3.
Find the end of the filament, and use
a snipper
to make a clean cut of the end.
4.
Open the door of the filament Bay.
5.
Hold the end of the filament straight up, and feed it into the guiding tube in the
filament bay.
6.
Keep feeding the filament until the end of the filament sticks out from the other
end of the guiding tube (You can open the top lid, and make sure the filament sticks
out).
Contact
Afinia 3D
: support@
afinia.com
12
Figure 4.3 Load Filament