Afinia H+1 3D Printer - Manual (Page 52)

8. Maintenance
8.1 Clean the Waste Tray
Located at the bottom of build chamber, a waste tray is introduced in
H+1
. 3D
printing with plastic extrusion technology is a messy business. Normally lots of
unwanted plastic scraps are generated here and there during printing and the post
processing stage. It is a nightmare to clean it up especially for the machine with full
enclosure.
The waste tray makes the cleaning work fast and easy. You can take the whole tray
out and dump the scraps inside the tray to a dumpster, and put it back to the bottom
of the machine.
8.2 Dual Filtration System
The H+1
has
an
upgraded air filtration system inherited from
H800+
with
a larger
and more effective
Dual Filtration System - the HEPA Filter and Activated Carbon
Filter. Both of the filters are located inside the build chamber, circulating the air
internally to reduce the toxic particles generated during the 3D printing process.
We suggest you change the filter every 3 months, or every 300 hours active printing
time.
To change the Filters
The filter system is located at the left side of the build chamber.
1. Use a screwdriver to unscrew the two screws in the front, remove the cover, and take out
the two used filters separately.
2. Take two new filters, place them into the slot, and push the slot back to the end.
3. Tighten the screws using screwdriver.
Contact
Afinia 3D
: support@
afinia.com
51