Afinia H480 3D Quick Start Guide User Manual

Afinia h480 3d printer, Unpackaging, For windows and mac os x

www.afinia.com

Unpackaging

for Windows and Mac OS X

Afinia H480 3D Printer

14.02.05

Unpacking Your Afinia 3D Printer

Your Afinia 3D Printer comes with the Installation Disc, Manual, Unpack and Setup Guide (this document),

and an Accessory Pack. Remove these items before removing the Printer from the box.

Carefully lift the Printer and foam from the box, removing the side foams while supporting the

printer.

Remove the foam between the Extruder and the printer.

There are two packaging clips on the Printer that are used to hold the platform and
extruder assembly in place during shipping. These clips must be removed before
the Printer is powered on.

Turn the Printer so the back is facing you.

The first clip will be just below the extruder
assembly, held in place with tape. Remove the

tape, then slide the clip down to remove it.

Save the packaging clips! It is highly recommended
that you reinstall these two clips if you need to ship the
Printer in the future.

The second clip is holding the Z-axis arm down. Gently lift the X-axis arm a few inches.
Do not lift the arm by the platform as this may affect the levelling of the platform!

Once the arm is raised, rotate the top of the clip towards the front of the Printer. The clip
will slide off the arm once it is in the correct position.

Accessory Pack Contents

Next, open the Accessory Pack and verify the contents with those listed below:

You will need the Filament Hanger, Filament Spool, Filament Tube, Hex Wrenches, Power Supply and Power Cable, and USB
Cable to complete the Hardware Setup and Installation. Please follow the instructions on the other side of this document.

For more detailed information on the Setup and Installation process, please review the Afinia 3D Printer User’s Manual.

USB Cable

Platform Probe and Data Cable

Filament Guide Tube

Filament Hanger

Nozzle Wrench & Hex Wrenches

Spare screws & washers

Tweezers

Exacto Knife and blades

Snipping Pliers

10. Putty Knife

11. FR-4 (Perf) Board

12. Gloves (1 pair)

13. Spool of Filament (1, Natural)

14. Power Cable

15. Power Supply