Afinia H+1 3D Printer User Manual
H+1 user manual
Table of contents
Document Outline
- 1. Safety and Printing Environment
- 1.1 Safety Precautions
- 1.2 Printing Environment
- 1.3 One Year Warranty
- 1.4 Compliance
- 2. Introduction
- 2.1 Main Parts of UP300
- 2.2 Specification Table
- 3. Unboxing
- 3.1 Unboxing the UP300
- 3.2 What’s in the box
- 3.3 Upgrade the Touchscreen Program
- 4. Printer Installation
- 4.1 Install the Print Board
- 4.2 Extruders
- 4.3 Load Filament
- 4.4 Connect the Power Cable
- 5. Touchscreen Instruction
- 5.1 Touchscreen Introductions
- 5.2 Material
- 5.3 Print
- 5.4 Calibrate
- 5.5 Information
- 5.7 Config
- 5.8 Initialize
- 6. First print
- 6.2 Install Software UP Studio
- 6.3 Connect UP300
- 6.5 Print Board Selection
- 6.6 Calibration
- 7. Start Printing
- 7.1 UP Studio Interface
- 7.2 Remove the Printed model
- 8. Maintenance
- 8.1 Clean the Waste Tray
- 8.2 Dual Filtration System