Afinia H+1 3D Printer - Manual (Page 29)

Wi-Fi Network Connection and Settings:
1.
Go to Config , enter Network Settings section.
2.
Toggle on Wi-Fi Network Connection .
3.
Find the desired Wi-Fi Network’s name in the list below.
4.
Tap the name to connect the Wi-Fi Network.
5.
The
H+1
is connect to the Wi-Fi Network successfully, when the red
exclamation mark disappeared, a interlock and Information icon appears.
6.
Tap the Information icon to edit the printer’s Wi-Fi Network Settings.
Contact
Afinia 3D
: support@
afinia.com
28
Figure 5.12 Wi-Fi Network Connection
Figure 5.13
Configure Section
Figure 5.14
Network Settings
Figure 5.15
Wi-Fi Network Information