beautypg.com

Using wps pin mode to connect to a network – Epson Workforce ES-60W Wireless Portable Document Scanner User Manual

Page 26

background image

26

4.

Enable WPS on your router by pressing the

WPS

button or enabling the WPS setting in your router

firmware.

The router enters WPS discovery mode for 2 minutes.

5.

Press and hold the

Wi-Fi connect button on the scanner until the ready,

Wi-Fi, and

Wi-Fi

AP lights flash alternately.

Note:

If you do not complete this step within 2 minutes, repeat these steps to try again.

When the ready,

Wi-Fi, and

Wi-Fi AP lights on the scanner stay on, the scanner is

connected to the network.

Note:

If the ready light stays on, but the

Wi-Fi and

Wi-Fi AP lights flash simultaneously,

connection has failed. Restart the scanner and router, move them closer together, and repeat these
steps to try again.

Parent topic:

Wi-Fi Protected Setup (WPS)

Using WPS PIN Mode to Connect to a Network

If you have a WPS-enabled wireless router that supports PIN mode, you can use Wi-Fi Protected Setup
(WPS) PIN mode to connect your scanner to the network.

1.

Follow the instructions on the

Start Here

sheet to install the scanner software on your computer.

2.

Find the WPS PIN number setting in your router's firmware.

3.

Make sure the scanner is turned off and set the

Wi-Fi switch to the

Wi-Fi position.

4.

Press and hold the

Wi-Fi connect button and slide and hold the

power switch for about ten

seconds until the ready,

Wi-Fi and

Wi-Fi AP lights flash alternately.