beautypg.com

Sony FE 2x Teleconverter User Manual

Page 48

background image

SilverBack V Camera-Mountable Fiber Optic Transmission System

© 2021 MultiDyne, Inc.

Made in the USA

Page

48

To prevent possible IP address conflicts:

Initially isolate the SilverBack V base unit and your computer from the rest of your network by

unplugging all devices except the SilverBack V base unit and your computer.

or

Use an Ethernet cable to connect the SilverBack V base unit directly to your computer.

From your computer, launch a web browser.

Power up the SilverBack V base unit.

In the address bar of the web browser, enter the preset IP address indicated on the DIP switch.

Wait approximately 30 seconds while network communications are established.

Verify that the SilverBack V base unit dashboard web page displays in the web browser.

Should the web page fail to display after a minute or two:

o

Click the refresh/reload button in your browser.

o

Verify that the Ethernet cables are properly connected.

o

Ensure that the LEDs on the Ethernet connector registers activity.

o

Verify that you have properly performed each step of this procedure.

If you and your IT team cannot establish a connection, contact MultiDyne Technical Support.

Custom User IP Address (DIP Switch 2)

With network communications established, you may wish to configure a custom static IP address

through the Frame Ethernet Settings box on the web page dashboard.

Establish communications with the SilverBack V base unit by using one of the preset IP

addresses, DHCP, or previously configured User IP address.

From your computer, launch a web browser and enter the previously established IP address.

When the dashboard launches, enter the desired user IP address in the Frame Ethernet Settings
box. (Ensure that your computer and the SilverBack V base unit are on the same subnet. Contact

your IT Department if you need help determining or configuring the network settings of your

computer.)

Verify the IP address. Click "Save IP". (The IP address is stored in non-volatile memory.)

Switch the DIP switch #2 to ON. (If this switch is already on, you may need to toggle for the

address to take effect.)

Verify the new IP address by entering it into a web browser address bar.