Sony FE 2x Teleconverter User Manual
Page 17
SilverBack V Camera-Mountable Fiber Optic Transmission System
© 2021 MultiDyne, Inc.
Made in the USA
Page
17
Serial Data Connections
Each camera chain in the SilverBack base unit is equipped with two dedicated user-configurable serial
data ports to control cameras or other peripherals. These DB-9 serial data ports support RS232, RS422,
LANC, and TTL level data. See pinouts for more details. Pre-made cables for specific camera and RCP
manufacturers are available
.
Part Number
Description
MDCAB00160
Cable Assembly, SilverBack V, base station-side RCP, for Sony 8-pin. 10'
long, DB9 male to Hirose MXR series 8-pin male.
MDCAB00180
Cable Assembly, SilverBack V, base station-side RCP, for Panasonic 10-
pin. 10' long, DB9 male to Hirose HR10A series 10-pin female.
MDCAB01068
Cable Assembly, SilverBack V, base station-side RCP, for Cannon LANC
RCP. 10' long, DB9 male to 3.5mm male plug.
MDCAB01256
Cable Assembly, SilverBack V, base station-side RCP, for Sony FS9
LANC. 10' long, DB9 male to 2.5mm female jack.
Frame Controller Connection
The frame controller in the SilverBack V base unit can be accessed via its 10/100 Mbps Ethernet port.
Connect this port to your facility network using Cat5e/Cat6 cabling.
The exact steps for connecting to your facility via an Ethernet network depends on the network
requirements of your facility. Contact your IT department before connecting to your facility network to
ensure that there are no IP address conflicts.