Sony FE 2x Teleconverter - Manual (Page 33)

SilverBack V Camera-Mountable Fiber Optic Transmission System
© 2021 MultiDyne, Inc. Made in the USA Page 33
MENU > Audio Settings > Intercom Settings > MIC Gain
To configure headset Sidetone Gain, navigate to the Audio Settings menu, select Intercom, then select
Sidetone Gain. Press Enter to toggle through the available Gain settings and stop at the desired setting.
MENU > Audio Settings > Intercom > Sidetone Gain
The Camera Intercom settings may also be configured remotely, from the webpage dashboard accessed
from the Base Unit.
Intercom Operation
Volume controls are provided on the camera unit control panel for adjusting the audio levels of
Intercom 1 (CH1), Intercom 2 (CH2), and Program (PGM) audio heard in the headset. The volume
controls allow both intercom channels and program audio to be heard in the headset simultaneously.
A LED above each channel’s set of volume control buttons will illuminate whenever audio is present on
that channel. When adjusting the volume, these LEDs will rapidly blink three times whenever the
minimum or maximum volume setting has been reached.
Two push-to-talk (PTT) switches are provided on the camera unit control panel, one for each intercom
channel. Each PTT switch provides Momentary or Latching operation of the headset microphone to
allow the operator to talk on a particular intercom channel, or on both channels simultaneously.
To talk on an intercom channel using Momentary mode:
1. For the desired channel, channel 1 or 2, press and hold the desired PTT switch, then speak into
the microphone.
2. The TALK LED and selected channel TALK LED will blink and the microphone will remain open
while the PTT switch is held.
3. When finished with the conversation, release the PTT button.
4. The microphone will shut off and the TALK LEDs will turn off.
To talk on an intercom channel using Latching mode for longer-term hands-free operation:
1. Quickly press and release the PTT switch for channel 1 or channel 2.
2. The microphone will latch open and TALK LED and the selected channel TALK LED will blink
continuously.
3. When finished with the conversation, quickly press and release the PTT switch again.
4. The microphone will shut off and the TALK LEDs will turn off.