Roland SH-4d Digital Desktop Synthesizer - Manual (Page 34)

Creating a Tone
34
RING
Parameter Controllers Value Explanation
Osc 1–2
Waveform [2] knob (on the top
screen only)
SINE, TRI,
SQR, SAW
This sets the waveform.
Coarse Tune PITCH -24–+24 Specifies the pitch in semitone steps (maximum ±2 octaves).
Fine Tune SHIFT+PITCH -50–+50 Specifies the pitch in cents (maximum ±50 cents).
Modulator
Tune TIMBRE -48–+48 Specifies the pitch for oscillator 2 in semitone steps (maximum ±4
octaves).
Mod Fine Tune SHIFT+TIMBRE -50–+50 Specifies the pitch for oscillator 2 in cents (maximum ±50 cents).
Bottom 1
[OSC 1] slider 0–127 Sets the loudness of oscillator 1’s signal that does not pass through
the ring modulator.
Shape
[OSC 2] slider 0–63 Distorts the waveform of oscillator 2, and adds a frequency
component one octave lower than the original waveform.
FXM [OSC 3] slider 0–16 Sets the depth of FXM frequency modulation.
Bottom 2
[OSC 4] slider 0–127 Sets the loudness of oscillator 2’s signal that does not pass through
the ring modulator.
FXM Speed
[OSC 3] button 1–4 Sets the method used for FXM frequency modulation.
Larger values produce a rougher sound, and smaller values produce a
more metallic sound.
WAVETABLE
Parameter Controllers Value Explanation
Wave Number
[2] knob (on the top screen
only)
1–31 Sets the wave number.
Coarse Tune
PITCH -24–
+24
Specifies the pitch in semitone steps (maximum ±2 octaves).
Pos LFO Depth TIMBRE 0–63 Sets how much the LFO is applied (depth) to the wave position.
Position [OSC 1] slider 0–127 Sets the wave position on the selected wave number.