Roland SH-4d Digital Desktop Synthesizer - Manual (Page 28)

Creating a Tone
28
SH-3D
Turn the [1] knob or press the [1]–[4] buttons in the OSC section to select an oscillator or LFO 2, and use the [2] knob to select the
oscillator or LFO 2 waveform.
Use the [1]–[3] sliders to set the volume for each oscillator. Set the speed of the LFO 2 cycle with the [4] slider.
Parameter Controllers Value Explanation
OSC 1–3
Osc 1–3
Waveform [2] knob (on the
top screen only)
This sets the waveform.
SAW
Sawtooth wave
SQR Square wave
TRI Triangle wave
SINE Sine wave
RAMP Ramp wave
JUNO Modulated sawtooth wave
TRI2 Triangle wave variation
TRI3 Triangle wave variation
SINE2 Sine wave variation
SSAW SuperSAW
NOISE White noise
LFO 2
Waveform [2] knob (on the
top screen only)
Sets the LFO 2 waveform.
SINE
Sine wave
TRI Triangle wave
SAW-UP Sawtooth wave
SAW-DW Sawtooth wave (negative polarity)
SQR Square wave
RND Random wave
TRP Trapezoidal wave
S&H Sample & hold wave (randomly changes
the output value once per cycle).
CHS Chaos wave
VSINE Deformed sine wave (randomly changes
the amplitude of the sine wave once per
cycle).
Osc 1–3
Coarse Tune PITCH -24–+24 Specifies the pitch in semitone steps
(maximum ±2 octaves).
Osc 1–3 Fine
Tune SHIFT+PITCH -50–+50 Specifies the pitch in cents (maximum ±50
cents).
Osc 1–3
PWM Depth TIMBRE 0–63 Sets how much the LFO is applied (depth)
to the PW (pulse width).
The pulse width is modulated according to
the LFO settings.