Roland SH-4d Digital Desktop Synthesizer - Manual (Page 108)

MFX Parameters
108
Chorus Type
Chorus
This is a stereo chorus. A filter is provided so that you can adjust the timbre of the chorus sound.
Parameter Value Explanation
Type
OFF, LPF, HPF Filter type
OFF: No filter is used
LPF: Cuts the frequency range above the Cutoff
Freq
HPF: Cuts the frequency range below the Cutoff
Freq
Cutoff
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500,
3150, 4000, 5000, 6300, 8000 [Hz]
Basic frequency of the filter
Pre Delay
0.0–100 [ms] Adjusts the delay time from the direct sound until
the chorus sound is heard.
Rate Sync
OFF, ON If this is ON, the rate synchronizes with the tempo
of the rhythm.
Tempo (Pattern)
Tempo (System) (P.76)
Rate 0.05–10.00 [Hz] Frequency of modulation
Rate Note Note (P.167)
Depth 0–127 Depth of modulation
Phase 0–180 [deg] Spatial spread of the sound
Low Gain -15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain -15–+15 [dB] Amount of boost/cut for the high-frequency range
Balance
D100: 0W–D0: 100W Volume balance between the direct sound (D) and
the chorus sound (W)
Level 0–127 Output Level