Roland SH-4d Digital Desktop Synthesizer - Manual (Page 105)

MFX Parameters
105
Flanger Type
Flanger
This is a stereo flanger (The LFO has the same phase for left and right.).
It produces a metallic resonance that rises and falls like a jet airplane taking off or landing.
A filter is provided so that you can adjust the timbre of the flanged sound.
Parameter Value Explanation
Type
OFF, LPF, HPF Filter type
OFF: No filter is used
LPF: Cuts the frequency range above the Cutoff
Freq
HPF: Cuts the frequency range below the Cutoff
Freq
Cutoff
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500,
3150, 4000, 5000, 6300, 8000 [Hz]
Basic frequency of the filter
Pre Delay
0.0–100 [ms] Adjusts the delay time from the direct sound until
the flanger sound is heard.
Rate Sync
OFF, ON If this is ON, the rate synchronizes with the tempo
of the rhythm.
Tempo (Pattern)
Tempo (System) (P.76)
Rate 0.05–10.00 [Hz] Frequency of modulation
Rate Note Note (P.167)
Depth 0–127 Depth of modulation
Phase 0–180 [deg] Spatial spread of the sound
Feedback
-98–+98 [%] Adjusts the proportion of the flanger sound that is
fed back into the effect.
Negative (-) settings will invert the phase.
Low Gain -15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain -15–+15 [dB] Amount of boost/cut for the high-frequency range
Balance
D100: 0W–D0: 100W Volume balance between the direct sound (D) and
the flanger sound (W)
Level 0–127 Output Level