Sony Cyber-shot RX10 III - Manual (Page 104)

Applies the exposure compensation value to control ambient light only.
[91] How to Use Using shooting functions Adjusting the exposure
Zebra
The zebra pattern will appear over part of an image if the brightness level of that part meets
the IRE level that you set. Use this zebra pattern as a guide to adjust the brightness.
1. MENU
→
(Custom Settings)
→ [Zebra] → desired setting.
Menu item details
Off:
Does not display the zebra pattern.
70/75/80/85/90/95/100/100+/Custom1/Custom2:
Adjusts the brightness level.
Hint
You can register multiple values for [Zebra] to check the exposure and the flare as well as
the brightness level. The settings for exposure confirmation and flare confirmation are
registered to [Custom1] and [Custom2] respectively by default.
To check exposure, set a standard value and the range for the brightness level. The
zebra pattern will appear on areas that fall within the range you set.
To check flare, set a minimum value for the brightness level. The zebra pattern will appear
on areas that exceed the value you set.
Note
The zebra pattern is not displayed during HDMI connection.
[92] How to Use Using shooting functions Adjusting the exposure
Exposure Set. Guide
You can set whether to display a guide when you change the exposure.
1. MENU
→
(Custom Settings)
→ [Exposure Set. Guide] → desired setting.
Menu item details