ProSoft Technology PS-QS-1x10-0781 - Manual (Page 83)

FieldServer Configuration Manual Page 83 of 90
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2269 Toll Free: (888) 509-1970 email: [email protected]
Error Description Action
10019 Check CSV file spelling.
10023
Protocol or Node_Name for Map_Descriptor
not detected
Check CSV file.
10025
Modbus/TCP - Client goes offline before
receiving a response to a poll.
Increase the timeout on the Modbus/TCP Client.
10026
There is no connection to one side of a virtual
wire. Ensure that a Client and a Server is configured for each
virtual wire
10027
Connection mode of Hot_Standby_Data only
supported in Hot Standby Mode1
10028 Could not find nor create a Node. Refer to 10010
10031
The data_points limit on the FieldServer has
been reached
Contact FST.
10032
A Server Node has been assigned to a Client
Map Descriptor OR a Client Node does not
have a connection/Server_Name
Check CSV file.
10033 Invalid length specified for Cable_Status_Bits See specification inSection 10.3.8.2
10034
An attempt to generate a write cache block
failed because the Node did not have a
connection.
10034
A protocol was specified in the configuration
file, but the required driver is not loaded in
the firmware (CB8MENU).
Correct the protocol in the configuration file Obtain
the correct DCC
10038
The FieldServer did not respond due to a Data
Array Age time exceeding the Cache Age time
limit.
Increase Cache Age setting in the configuration file.
10039
There was a message overrun on Modbus TCP
slave driver. The Client is polling too often for
the FieldServer to respond and there is more
than one message in the in-buffer. There
should be overrun statistics on the Server
Connection in question.
Increase the timeout on the Client device.
10040
Same as 10039, except the overrun is more
than two messages.
10041
Invalid move function specified in
configuration file, or move not defined.
Fix the configuration error
10042 High and Low Scaling values are equal
10045
Move overruns Data Array. This usually means
that the offset PLUS the length of the Move
command is larger than the length of the Data
Array.
Actions: Check Data_Array Length:
Check Move settings
Target_Offset,
Source_Offset, Client_Offset,
Server_Offset, Feedback_Offset, Mode_Offset, Length
10046
Move Offset lies outside the Data Array. This
usually means that the offset of the Move
command is larger than the length of the Data
Array.
10047 Could not find Source Data Array for Move. Make sure that the specified Data Array exists before
specifying move.
10048 Could not find Target Data Array for Move.