ProSoft Technology MVI94-DNP - Manual (Page 34)

Configuration MVI94-DNP ♦ Flex I/O
User Manual DNP 3.0 Server over Ethernet Communication Module
Page 34 of 131 ProSoft Technology, Inc.
December 17, 2010
3.9 Uploading and Downloading the Configuration File
ProSoft modules are shipped with a pre-loaded configuration file. In order to edit
this file, you may transfer the file from the module to your PC or locate and load
the file from the distribution CD-ROM supplied with the module. After editing, you
must transfer the file back to the module for your changes to take effect.
This section describes these procedures.
Important: The illustrations of configuration/debug menus in this section are intended as a general
guide and may not exactly match the configuration/debug menus in your own module. For specific
information about the configuration/debug menus in your module, refer to The Configuration/Debug
Menu (page 43).
3.9.1 Transferring the Configuration File to Your PC
1 Connect your PC to the Configuration/Debug port of the module using a
terminal program such as HyperTerminal. Press [?] to display the main
menu.
2 Press [>] key (Send Module Configuration). The message "Press Y to
confirm configuration send!" is displayed at the bottom of the screen.