ProSoft Technology ILX56-MM - Manual (Page 69)

ILX56-MM ♦ ControlLogix Platform Diagnostics and Troubleshooting
InRAx Message Manager for Industrial Communication User Manual
ProSoft Technology, Inc. Page 69 of 112
February 6, 2012
5.2 Setup Mode
Setup Mode temporarily sets the module's network port settings to their default
values. Setup Mode also allows you to reset the default
ADMIN
password.
To go into Setup Mode, you must remove the module from the ControlLogix rack.
Install the Setup Mode jumper on the back of the module (page 16). Then plug
the module back into the ControlLogix rack. The module is now in Setup Mode
until you remove the Setup Mode jumper.
When in Setup Mode, the module's network port settings are temporarily set to
their default values. Port 1 is set to a static IP address of 192.168.1.254. Port 2 is
set up to get its IP from a DHCP server.
When you start the configuration tool while the module is in Setup Mode, a red
indicator is displayed on the status bar at the bottom of the
page.
User login is disabled in this mode and all Administrator functions are available to
the user.
To reset the default "admin" password, click the R
ESET A DMIN P ASSWORD
button on the status bar. This action restores the default admin user and
password, and assigns Administrator privilege.
To reset the network port settings, go to the Network Settings page (page 23).
When you have finished resetting the network port settings and/or the default
admin password,
1 Close your web browser
2 Remove the module from the ControlLogix rack
3 Remove the Setup Mode jumper
4 Reinstall the module in the ControlLogix rack.