ProSoft Technology ILX56-MM - Manual (Page 35)

ILX56-MM ♦ ControlLogix Platform Administration
InRAx Message Manager for Industrial Communication User Manual
ProSoft Technology, Inc. Page 35 of 112
February 6, 2012
2.7 Scanner Modes
The scanner mode controls the scanning of Triggers (page 57) and the transfer
of data between Devices. The scanner can be in one of the following modes:
In S
TOP
mode, Triggers are not scanned and none of the Interfaces are
active. The scanner only goes into Stop mode when a serious error has
occurred. You cannot put the scanner into Stop mode yourself.
In I DLE
mode, Triggers are not scanned but the Interfaces are active. In Idle
mode, you can configure the scanner using the Configuration Editor.
In R UN
mode, Triggers are scanned and the Interfaces are active. Data is
actively transferred between controllers based on Trigger logic. You cannot
configure the scanner while it is in Run mode.
You must be logged into the module with Project or Administrator privilege to
change the scanner mode. To change the scanner mode, click the I
DLE
or
R UN
buttons on the status bar at the bottom of the page. The following
illustration shows the ILX56-MM in I
DLE
mode.