ProSoft Technology ILX56-MM - Manual (Page 23)

ILX56-MM ♦ ControlLogix Platform Administration
InRAx Message Manager for Industrial Communication User Manual
ProSoft Technology, Inc. Page 23 of 112
February 6, 2012
2.2 Network Settings
To open the N
ETWORK S ETTINGS
page, click the A
DMINISTRATION
tab, and then
click the N
ETWORK
tab.
The module has two RJ45 Ethernet ports, located at the bottom of the front panel
on the module. You can configure the following settings for each port.
Disabled
Static IP Address
o
Subnet Mask
o
Default Gateway (optional)
DHCP (auto-configured through a DHCP server)
Click the S
AVE
button to update these settings on the module.
Note: The only way to use both ports on the same subnet or Ethernet is to use a redundant wire
solution. Without this each port must be on a separate Ethernet network.