ProSoft Technology ILX56-MM - Manual (Page 16)

Start Here ILX56-MM ♦ ControlLogix Platform
User Manual InRAx Message Manager for Industrial Communication
Page 16 of 112 ProSoft Technology, Inc.
February 6, 2012
1.5 Setup Jumper
There is one S
ETUP J UMPER
located on the back of the module, labeled J1. The
Setup Jumper acts as "write protection" for the module's firmware. In "write
protected" mode, the Setup pins are not connected, and the module's firmware
cannot be overwritten.
The following illustration shows the ILX56-MM jumper configuration, with the
Setup Jumper OFF.
If you need to update the firmware, apply the Setup jumper to both pins.
Note: If you are installing the module in a remote rack, you may prefer to leave the Setup pins
jumpered. That way, you can update the module's firmware without requiring physical access to the
module.