ProSoft Technology ILX56-MM - Manual (Page 18)

Start Here ILX56-MM ♦ ControlLogix Platform
User Manual InRAx Message Manager for Industrial Communication
Page 18 of 112 ProSoft Technology, Inc.
February 6, 2012
1.7 Connect to the Module's Web page
If your network is configured to use IP addresses in the range 192.168.1.xxx,
open Microsoft Internet Explorer (version 7, or higher), and connect to the
following address:
http://192.168.1.254
If your network is configured to use a different IP range, follow these steps:
1 Disconnect your PC from the network
2 Connect the Ethernet cable between the Ethernet port on your PC and Port 1
on the module
3 Temporarily change the IP address and Subnet Mask on your PC to match
the network configuration on the module:
IP address: 192.168.1.1
Subnet mask: 255.255.255.0
Important: Make a note of your IP Address settings. You will need to restore these settings before
you reconnect to the network.
4 Open Microsoft Internet Explorer (version 7, or higher) and connect to the
following address:
http://192.168.1.254
5 Click the L OGIN
button at the bottom of the screen, and use the following
username and password to login.
Username:
admin
Password:
admin
6 Click the A DMINISTRATION
tab, and then the N
ETWORK
tab. Configure the IP
Address, Subnet Mask, and Default Gateway to work with your network.
7 Click the S AVE
button to apply the updated settings.
8 Change the IP Address and Subnet Mask settings on your PC back to their
original values, and then reconnect your PC to the network.