ProSoft Technology ILX56-MM - Manual (Page 42)

Configure the ILX56-MM module ILX56-MM ♦ ControlLogix Platform
User Manual InRAx Message Manager for Industrial Communication
Page 42 of 112 ProSoft Technology, Inc.
February 6, 2012
Each Interface and Device has a unique Name, a Timeout, and addressing
information.
The Timeout specifies the timeout value in milliseconds to be used in
communicating with the device.
The addressing information contains information to address the device on the
network or in the rack where the device is located.
Depending on the Interface Type and Device Type, other parameters may also
be available. The following table describes the addressing parameters for each
interface/device type.
Parameter Description
Interfaces Addressing is specified as a slot number.
ControlNet bridge Addressing is specified as a node number.
DHRIO bridge Addressing is specified as a channel and node number.
DH485 bridge Addressing is specified as a channel and node number.
Bridges (ControlLogix Backplane)
Devices are configured under a bridge interface in the local rack. Select the
D
EVICES
node in the Configuration Editor tree. The content pane will display a
table containing all of the Devices defined for that bridge.
The ILX56-MM supports the following bridges:
EtherNet/IP
®
DHRIO
DH485
ControlNet ™