PLANET ADN-4101 - Manual (Page 69)

802.11n Wireless ADSL2/2+ Router
ADN-4101
3.8.2 Traceroute
Choose Diagnostic >Traceroute and the following page appears. By Traceroute Diagnostic, you can track the route
path through the information which is from your computer to the Internet other side host.
The following table describes the parameters and buttons on this page.
Field Description
Host Enter the destination host address for diagnosis.
NumberOfTries Number of repetitions.
Timeout Put in the timeout value.
Datasize Packet size.
DSCP Differentiated Services Code Point, You should set a value between
0-63.
MaxHopCount Maximum number of routes.
Interface Select the interface.
Traceroute Click start traceroute.
3.8.3 OAM Loopback
Choose Diagnostic > OAM Loopback and the page shown in the following figure appears. On this page, you can
use VCC loopback function to check the connectivity of the VCC. The ATM loopback test is useful for troubleshooting
problems with the DSLAM and ATM network.
Click Go! to start testing.
64