PLANET ADN-4101 - Manual (Page 40)

802.11n Wireless ADSL2/2+ Router
ADN-4101
35
Field Description
Apply Changes
Click it to apply the settings temporarily. If you want to save the settings of this page
permanently, click Save in the lower left corner.
3.4.3.2 Security
Choose WLAN> Security and the following page appears.
The following table describes the parameters on this page:
Field Description
Encryption
Configure the wireless encryption mode. You can choose None, WEP,
WPA (TKIP), WPA (AES), WPA2 (AES), WPA2 (TKIP) or WPA2 Mixed.
Wired equivalent privacy (WEP) encrypts data frames before
transmitting over the wireless network.
Wi-Fi protected access (WPA) is a subset of the IEEE802.11i security
specification draft.
WPA2 Mixed is the collection of WPA and WPA2 encryption modes.
The wireless client establishes the connection between the modem
through WPA or WPA2.
Key differences between WPA and WEP are user authentication and
improved data encryption.
Set WEP Key
It is available when you set the encryption mode to WEP. Click it, the
Wireless WEP Key Setup page appears.
WPA Authentication Mode
Select Personal (Pre-Shared Key), enter the pre-shared key in the
Pre-Shared Key field.
Select Enterprise (RADIUS), and enter the port, IP address, and
password of the Radius server. You need to enter the username and
password provided by the Radius server when the wireless client connects
the modem.
If the encryption is set to WEP, the modem uses 802.1 X authentication,
which is Radius authentication.