PLANET ADN-4101 - Manual (Page 18)

802.11n Wireless ADSL2/2+ Router
ADN-4101
On the Web configuration page, you can click Apply Changes to
save the settings temporarily. If you want to save the settings of this
page permanently, clicks save of Attention that appears at the
bottom of the Web page after the configuration.
3.2 Wizard
When subscribing to a broadband service, you should be aware of the method by which you are connected to the
Internet. Your physical WAN device can be either PPP, ADSL, or both. The technical information about the properties
of your Internet connection is provided by your Internet Service Provider (ISP). For example, your ISP should inform
you whether you are connected to the Internet using a static or dynamic IP address, and the protocol that you use to
communicate on the Internet.
In the navigation bar, choose Wizard. The page shown in the following figure appears. The Wizard page guides fast
and accurate configuration of the Internet connection and other important parameters. The following sections
describe these various configuration parameters. Whether you configure these parameters or use the default ones,
click NEXT to enable your Internet connection.
The following table describes the parameters on this page:
Field Description
VPI
Virtual path identifier (VPI) is the virtual path between two points in an ATM network. Its valid
value is in the range of 0 to 255. Enter the correct VPI provided by your ISP. By default, VPI is
set to 0.
VCI
Virtual channel identifier (VCI) is the virtual channel between two points in an ATM network. Its
valid value is in the range of 32 to 65535. (0 to 31 is reserved for local management of ATM
traffic) Enter the correct VCI provided by your ISP. By default, VCI is set to 35.
13