beautypg.com

2 wan, 2 wan …………………………………………………………………………………………29 – PLANET ADN-4101 User Manual

Page 34

background image

802.11n Wireless ADSL2/2+ Router

ADN-4101

29

Field

Description

Delete Selected

Select a row in the DHCP Static IP Table, then click it, this row is deleted.

Reset

Click it to refresh this page.

DHCP Static IP Table

It shows the assigned IP address based on the MAC address.

3.4.2 WAN

Choose Network > WAN and the WAN page that is displayed contains WAN, Auto PVC, ATM Settings and ADSL
Settings
.

3.4.2.1 WAN

Click WAN in the left pane and the page shown in the following figure appears. On this page, you can configure WAN
interface of your router.

The following table describes the parameters on this page:

Field

Description

Default Route Selection

You can select Auto or Specified.

VPI

The virtual path between two points in an ATM network, ranging
from 0 to 255.

VCI

The virtual channel between two points in an ATM network, ranging
from 32 to 65535 (1 to 31 are reserved for known protocols)

Encapsulation

You can choose LLC and VC-Mux.

Channel Mode

You can choose 1483 Bridged, 1483 MER, PPPoE, PPPoA, 1483
Routed
or IPoA.

Enable NAPT

Select it to enable Network Address Port Translation (NAPT)
function. If you do not select it and you want to access the Internet
normally, you must add a route on the uplink equipment. Otherwise,
the access to the Internet fails. Normally, it is enabled.

Enable IGMP

You can enable or disable Internet Group Management Protocol

This manual is related to the following products: