PLANET ADN-4101 - Manual (Page 55)

802.11n Wireless ADSL2/2+ Router
ADN-4101
The following table describes the parameters and buttons on this page:
Field Description
Enable Select it to use static IP routes.
Destination Enter the IP address of the destination device.
Subnet Mask Enter the subnet mask of the destination device.
Next Hop Enter the IP address of the next hop in the IP route to the destination device.
Metric The metric cost for the destination.
Interface The interface for the specified route.
Add Route Click it to add the new static route to the Static Route Table.
Update Select a row in the Static Route Table and modify the parameters. Then click it to
save the settings temporarily.
Delete Selected Select a row in the Static Route Table and click it to delete the row.
Show Routes Click it, the IP Route Table appears. You can view a list of destination routes
commonly accessed by your network.
Static Route Table A list of the previously configured static IP routes.
Click Show Routes and the page shown in the following figure appears. The table shows a list of destination routes
commonly accessed by your network.
50