PLANET ADN-4101 - Manual (Page 56)

802.11n Wireless ADSL2/2+ Router
ADN-4101
3.6.1.2 RIP
Click RIP in the left pane and the page shown in the following figure appears. If you are using this device as a
RIP-enabled router to communicate with others using Routing Information Protocol (RIP), enable RIP. This page is
used to select the interfaces on your devices that use RIP, and the version of the protocol used.
The following table describes the parameters and buttons on this page:
Field Description
RIP You can select OFF or ON. In this example, OFF is selected.
Apply Click it to save the settings of this page.
Interface Choose the router interface that uses RIP.
Receive Version Choose the interface version that receives RIP messages. You can choose
RIP1, RIP2, or Both.
Choose RIP1, indicates the router receives RIP v1 messages.
Choose RIP2, indicates the router receives RIP v2 messages.
Choose Both, indicates the router receives RIP v1 and RIP v2
messages.
Send Version The working mode for sending RIP messages. You can choose RIP1 or
RIP2.
Choose RIP1 indicates the router broadcasts RIP1 messages only.
Choose RIP2 indicates the router multicasts RIP2 messages only.
Add Click it to add the RIP interface to the Rip Config List.
Delete Select a row in the Rip Config List and click it to delete the row.
3.6.2 NAT
Choose Advanced > NAT and the page shown in the following figure appears. The page displayed contains Setup
DMZ, Virtual Server, NAT Forwarding, ALG, NAT Exclude IP, Port Trigger, FTP ALG Port, and NAT IP Mapping.
3.6.2.1 Setup DMZ
Demilitarized Zone (DMZ) is used to provide Internet services without sacrificing unauthorized access to its local
private network. Typically, the DMZ host contains devices accessible to Internet traffic, such as web (HTTP) servers,
FTP servers, SMTP (e-mail) servers and DNS servers.
Click DMZ in the left pane and the page shown in the following figure appears.
51