PLANET ADN-4101 - Manual (Page 39)

802.11n Wireless ADSL2/2+ Router
ADN-4101
3.4.3 WLAN
Choose Network > WLAN. The WLAN page that is displayed contains Basic, Security, Access Control List,
MBSSID, Advanced, WPS, WDS, and WDS Security.
3.4.3.1 Basic
Choose WLAN > Basic and the following page appears. On this page, you can configure the parameters for wireless
LAN clients that may connect to the modem.
The following table describes the parameters on this page:
Field Description
Band
Choose the working mode of the modem. You can choose from drop-down list.
Mode
Choose the network model of the modem, which varies according to the software. By
default, the network model of the modem is AP.
SSID
The service set identification (SSID) is a unique name to identify the modem in the
wireless LAN. Wireless stations associating to the modem must have the same SSID.
Enter a descriptive name that is used when the wireless client connecting to the
modem.
Channel Number
A channel is the radio frequency used by 802.11b/g wireless devices. There are 14
channels (from 1 to 14) available depending on the geographical area. You may have
a choice of channels (for your region) and you should use a different channel from an
adjacent AP to reduce the interference. Interference and degrading performance
occurs when radio signal from different APs overlap.
Choose a channel from the drop-down list box.
Radio Power
You can choose the transmission power of the radio signal. The default one is 100%.
It is recommended to choose the default value 100%.
Show Active Clients
Click it to view the information of the wireless clients that are connected to the
modem.
34