PLANET ADN-4101 - Manual (Page 61)

802.11n Wireless ADSL2/2+ Router
ADN-4101
3.6.4 IP QoS
Choose Advance > IP QoS and the page shown in the following figure appears. Entries on the QoS Rule List are
used to assign the precedence for each incoming packet based on physical LAN port, TCP/UDP port number, source
IP address, destination IP address and other information.
Step 1 Enable IP QoS and click Apply to enable IP QoS function.
Step 2 Click add rule to add a new IP QoS rule.
The page shown in the following figure appears.
The following table describes the parameters and buttons on this page:
Field Description
IP QoS Select to enable or disable IP QoS function. You need to enable IP QoS if you
want to configure the parameters on this page.
QoS Policy You can choose stream based, 802.1p based, or DSCP based.
Schedule Mode You can choose strict prior or WFQ (4:3:2:1).
Source IP The IP address of the source data packet.
Source Mask The subnets mask of the source IP address.
Destination IP The IP address of the destination data packet.
Destination Mask The subnets mask of the destination IP address.
Source Port The port of the source data packet.
Destination Port The port of the destination data packet.
Protocol The protocol responds to the IP QoS rules. You can choose TCP, UDP, or ICMP.
Phy Port The LAN interface responds to the IP QoS rules.
Set priority The priority of the IP QoS rules. P0 is the highest priority and P3 is the lowest.
Delete Select a row in the QoS rule list and click it to delete the row.
Delete all Select all the rows in the QoS rule list and click it to delete the rows.
56