PLANET ADN-4101 - Manual (Page 20)

802.11n Wireless ADSL2/2+ Router
ADN-4101
After setting, click Next and the page as shown in the following figure appears.
The following table describes the parameters on this page:
Field Description
Obtain an IP address
automatically Select it, the DHCP assigns the IP address for PPPoE connection.
Use the following IP address
When selecting it, you need to enter the IP address for PPPoE
connection, which is provided by your ISP.
Enable NAT
Select the checkbox to enable network address translation (NAT). If you
do not select it and you want to access the Internet normally, you must
add a route on the uplink equipment. Otherwise, the access to the Internet
fails. Normally, it is required to enable NAT.
After setting, click Next and the page as shown in the following figure appears.
15