PLANET WNAP-3000PE - Manual (Page 84)

Appendix D
Command Line Interface
Overview
If desired, the Command Line Interface (CLI) can be used for configuration. This
creates the possibility of creating scripts to perform common configuration changes.
The CLI requires a Telnet connection to the Wireless Access Point.
Using the CLI - Telnet
1. Start your Telnet client, and establish a connection to the Access Point.
e.g.
Telnet 192.168.0.228
2. You will be prompted for the user name and password. Enter the same login
name and password as used for the HTTP (Web) interface.
The default values are admin for the User Name, and password for the Pass-
word.
3. Once connected, you can use any of the commands listed in the following Com-
mand Reference.
Command Reference
The following commands are available.
config vap Config Virtual AP X
? Display CLI Command List
help Display CLI Command List
get 11nampdu Set 11n A-MPDU Aggregation Mode
get 11namsdu Set 11n A-MSDU Aggregation Mode
get 11nguardinterval Set 11n Guard Interval Mode
get 11nsubchannel Set 11n Extension Sub-Channel
get 11nradioband Set 11n Radio Band
get 802.11d Display 802.11d Mode
get acctserver Display Accounting Server
get acctport Display Accounting Port
get acctsecret Display Accounting Secret
get acl Display Access Control Status
get active Display VAP Active (up) Mode
get aging Display Idle Timeout Interval
get authentication Display Authentication Type of WEP
79