beautypg.com

Epson 2000 User Manual

Page 65

background image

This section includes steps for the following procedures:

Removing the mounting frames from the hard disk drive

(if necessary)

Installing the hard disk drive below the diskette drive in

the mounting bracket

Replacing the mounting bracket and drives in the computer

Connecting the drive cables.

If you have two hard disk drives, one must be configured as

the master (which contains your operating system), and the

other as the slave. Be sure to check the jumper settings on the

hard disk drive before you install it.

Also, you may need to know the number of cylinders, heads,

sectors, etc., if the hard disk drive auto-sensing feature in

SETUP is unable to correctly identify your drive. The hard disk

drive table used in the SETUP program is included in

Appendix A, along with a table of jumper settings for
high-capacity EPSON drives. If your drive is not listed or you
need more information, see the documentation that came with

your drive or contact the manufacturer.

4-1

Installing and Removing Drives