Stopping a command or program – Epson 2000 User Manual
Page 38
Note
The 3.5-inch drive installed in your computer is drive A. If
you install another diskette drive, it is drive B. You can
change the drive assignments through SETUP.
To insert a diskette into a 5.25-inch drive, hold the diskette with
the label facing up and the read/ write slot leading into the
drive. Slide the diskette into the drive and then turn down the
latch to secure it.
When you want to remove the diskette, make sure the drive
light is off; then press the release button or turn the latch.
Remove the diskette and store it properly.
Caution
Never remove a diskette or reset or turn off the computer
while a diskette drive light is on. You could lose data. Also,
remove all diskettes before you turn off the computer.
Stopping a Command or Program
You may sometimes need to stop a command or program while
it is running. If you have entered an MS-DOS
®
or application
program command that you want to stop, try one of the
following:
Press
Pause
Hold down
Ctrl
and press C
Hold down
Ctrl
and press
Break.
Using Your Computer
2-3