Epson 2000 - Manual (Page 28)

Setting the Hard Disk Drive(s)
Your system comes with a hard disk auto-sensing feature that
automatically detects the type of hard disk drive(s) installed in
your computer. (See Appendix A for a list of hard disk drive
types and their parameters.) The SETUP program allows you to
view or change the parameters for your hard disk drive.
If you are using an older drive or a preformatted drive, it may
not support the auto-sensing feature. If the SETUP program
displays drive parameters that do not match your drive, you
need to select a different drive type or define your own drive
type or reformat the disk. See the instructions below on
defining your own drive type.
Using the auto-sensing feature
To allow the computer to automatically detect your hard disk
drive, follow these steps:
1. Move the cursor to Hard Disk 1 or 2 and press + or -
until you see AUTO DETECT 1 or AUTO DETECT 2. Select
AUTO DETECT
1 for your first hard disk drive and
AUTO DETECT 2 for your second hard disk drive.
2. Press
E
SC to return to the SETUP menu and press F4 to save
your settings. The computer restarts and automatically
detects the hard disk drive. The next time you run SETUP,
you’ll see the parameters detected by the auto-sensing
feature.
Setting Up Your System 1-13