Epson 2000 - Manual (Page 21)

Connecting a Printer or Other Device
Your computer has one bi-directional parallel and two serial
ports. To connect a printer or other peripheral device, follow
the appropriate instructions below.
Using the parallel port
Follow these steps to connect a parallel printer to your
computer:
1. Plug the connector end of the printer cable into the
computer’s PARALLEL port. If the connector has retaining
screws, tighten them.
2. Connect the other end of the cable to the printer. To secure
the cable, squeeze the clips at each side of the printer port
and push them into place.
3. Plug the printer’s power cord into a grounded electrical
outlet.
Using the serial ports
If you have a printer, modem, or other device with a serial
interface, you can connect it to one of the serial (RS-232C) ports.
Make sure you have a cable compatible with a DB-9P connector.
To connect a serial device, insert the connector into one of the
ports marked COM1 and COM2. If you are connecting only one
serial device, use the COM1 port. If you want to assign COM1 as
COM3 or COM2 as COM4, see Chapter 3 for information on
jumper settings.
1-6 Setting Up Your System