beautypg.com

Turning off the computer, Running the setup program – Epson 2000 User Manual

Page 24

background image

If your system is configured to automatically start Microsoft

Windows or a word processing program, or has a different

operating system, you will see the first menu or screen of that

program displayed at this point. If your system is not

configured to start like this, you will see the MS-DOS operating

prompt, such as

C:\>

or A:\>, each time you turn on the

computer.

Now follow the instructions below to configure your system

using the SETUP program.

Turning Off the Computer

Whenever you turn off your system, follow these steps:

1.

Save your data and exit any application program you are

using.

2.

Check the hard disk drive light and the diskette drive light(s)

to make sure they are not on. Do not turn off the computer

if a drive light is on, because you can damage the drive or
lose data.

3.

Remove any diskette(s) from the diskette drive(s).

4.

Press the power button to turn off the computer and then

turn off the monitor, printer, and any other peripheral

devices.

Running the SETUP Program

Be sure to run SETUP the first time you use your computer, so

you can verify or update the configuration information. You

also may need to run SETUP again later if you change your

configuration.

Setting Up Your System

1-9