Epson 2000 - Manual (Page 63)

Post-installation procedures
Some of the steps in this chapter may not apply for the drive
you are installing. See the documentation that came with your
drive for more information.
Removing the Diskette Drive and Mounting
Bracket
Your computer has a 3.5-inch diskette drive installed in a
mounting bracket. (You may also have a hard disk drive
installed in the bracket.) In order to install a hard disk drive,
additional diskette drive, or any other type of drive, you must
first remove the drive(s) and mounting bracket. Refer to the
illustrations below and follow these steps:
1. Remove the two cables from the diskette drive. Grasp the
connectors and pull them straight out so you do not bend
the pins; do not pull on the cables. (If necessary, remove the
cables from the hard disk drive also.)
4-2 Installing and Removing Drives