Connecting the power cord, Turning on the computer – Epson 2000 User Manual
Page 22
Connecting the Power Cord
Follow these steps to connect the power cord:
1.
Plug the power cord into the power inlet on the back panel
of the computer.
WARNING
To avoid an electric shock, be sure to plug the cord into
the computer before plugging it into the wall outlet.
2.
Plug the other end of the power cord into an appropriate
grounded electrical outlet.
After you connect the components of your system, you are
ready to turn on the power.
Turning On the Computer
Before you turn on your computer, be sure to read the
Important Safety Instructions at the beginning of this manual.
Follow these steps to turn on your system :
1.
If there is a protective card in the diskette drive, remove it
now.
2.
Turn on the monitor, printer, and any other peripheral
devices connected to the computer.
3.
If you do not have a hard disk with an operating system
loaded on it, insert your main operating system diskette in
drive A.
Setting Up Your System
1-7